Zilog Z8F0130 Bedienungsanleitung PDF herunterladen (Seite 121)

UM013037-1212 Project Menu

Zilog Developer Studio II – Z8 Encore!

User Manual

You can add or edit your additional directives in the Additional Linker Directives dialog

box. The manually inserted directives are always placed in the same place in your linker

command file: after most of the automatically generated directives and just before the final

directive that gives the name of the executable to be built and the modules to be included

in the build. This position makes your manually inserted directives override any conflict-

ing directives that occur earlier in the file, so it allows you to override particular directives

that are autogenerated from the project settings. (The RANGE and ORDER linker 

directives are exceptions to this rule; they do not override earlier RANGE and ORDER

directives but combine with them.) Use caution with this override capability because some

of the autogenerated directives might interact with other directives and because there is no

visual indication to remind you that some of your project settings might not be fully taking

effect on later builds. If you must create a complex linker command file, contact Zilog

Technical Support for assistance. See the Zilog Technical Support

section on page 6.

If you have selected the

Additional Directives checkbox, your manually inserted direc-

tives are not erased when you build your project. They are retained and reinserted into the

same location in each newly created linker command file every time you build your proj-

ect.

In earlier releases of ZDS II, it was necessary to manually insert a number of directives if

you had a C project and did not select the Standard C Start-up Module. This task is no lon-

ger necessary. The directives required to support a C start-up module are now always added

to the linker command file. The only time these directives are not added is if the project is

an Assembly Only project.

Use Existing

Use the following procedure if you do not want a new linker command file to be generated

when you build your project:

1. Select the

Use Existing button.

2. Click the

Browse button ( ). The Select Linker Command File dialog box is dis-

played.

Note:

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 213 214

Keine Kommentare

Zilog Z8F0130 Bedienungsanleitung Seite 121