Zilog Z86C36 Bedienungsanleitung PDF herunterladen (Seite 31)

Z86C36

ICEBOX

Setup and Installation UM002202-1001

Resetting

Press the RESET button on the ICEBOX to reset the state of the target

device and the status that was established using ZDS.

For example, the ICEBOX sets the program counter to 000Ch.

After reset, wait until the Ready LED is ON and has finished blinking

before starting ZDS. Refer to the LED Operation section of this chapter

for more details.

Always press the RESET button on the ICEBOX before starting

ZDS.

LED Operation

ZiLOG ICEBOXes use LEDs to communicate the different hardware

states. The following table gives a description of the LEDs. The

ICEBOX’s LED’s are located on the right front of the ICEBOX. See

Table 3.

Table 3. Front LED Assignments

LED Indication Description

READY On

Off

Communicating in Bisync Mode and waiting for command

Communicating in ASCII Mode or executing Bisync command

RUN On

Off

Running user code

Not running user code

OTP On

Off

The ICEBOX is performing OTP programming

The ICEBOX completed OTP programming

PWR On

Off

Blink

ICEBOX is powered up and Self Test is completed

Power is off

ICEBOX is self-testing

Note:

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

Keine Kommentare

Zilog Z86C36 Bedienungsanleitung Seite 31